SUBWAY USB CONTROLLER

Subway USB gives your Amiga up to four individual USB ports to add an array of useful USB peripherals to your Amiga such as CD drives, hard disks, flash drives, mice and memory card readers.

Subway requires an Amiga equipped with a suitable clockport:

Amiga 1200
Amiga 600 equipped with A602, A603 or A604 memory expansion
Amiga 2000/3000/4000(T) with a Zorro Clockport expansion card such as Kickflash, X-Surf or Buddha IDE


Technical data

compatible with USB 1.1 and USB 2.0 specification (no highspeed mode) integrated 4x port hub all ports are protected against overvoltage and short circuit integrated power management on port by port base power saving 3.3V technology compatible with all 68020/030/040/060 and PPC accelerator cards no mechanical problems with Amiga 1200 busboards compatible with all Amiga 1200 tower housings standard Amiga 1200 clockport or A604 clockport connector highspeed clockport for fast data transfers works with all Amiga 1200 compatible clockports

Subway USB

Software support

compatible with AmigaOS 3.1, 3.5, 3.9, 4.0, 4.1 USB stack is fully compatible with MorphOS integration into Amiga OS via system drivers comfortable control of USB stack by GUI (MUI) driver for USB mouse and keyboard (HID devices) driver for parallel interface (printers) and flash card readers (SCSI emulation) further drivers (webcam, digicam) are available by third companies

Manage USB devices in Trident software (included) (click image to expand)

Included in delivery
1 x 9cm clockport flat ribbon cable
1 x SUBWAY USB controller card
2 x holding plates with two USB connectors each
1 x detailed English/German installation manual
1 x registration card
1 x disk with driver software

Requirements
Amiga OS 3.1 or higher
Poseidon USB software (supplied) ideally requires an 68030 or higher processor. Note that Subway USB can still be used with 68000 or 68020 with reduced functionality through the third-party ANAIIS USB Software (available separately from Aminet).
100% compatible Amiga 1200 clockport (see also tested boards)
power supply with 2.0 Ampere minimum on 5V (each used USB port will use a maximum of 500mA, depending on connected device)

We recommend using a selfpowered hub when connecting more bus-powered high current (500mA) devices. Using AC adaptors with USB devices (if possible) is also encouraged. Powering all four USB ports with its maximum load of 500mA can lead to problems on some Amiga 1200 models.

Don't Forget:
DENEB USB 2.0 CONTROLLER
24X EXTERNAL CDROM DRIVE (USB)
4 PORT INTERNAL USB HUB
4 PORT SELF-POWERED EXTERNAL USB HUB
ANTI STATIC WRIST BAND